Amplifier type ModMAGTM M 5000
for flanged process connections
Up to 12 years battery life span
Accuracy better than ±0,5 %
Measuring range of 0,03 to 12 m/s
Sizes from DN 15 to DN 600
IP 67 / IP 68 protection class
RS 232, IrDA, ModBus? interfaces
The M 5000 is a battery-powered electromagnetic flow meter with a very high accuracy even at very low
flows. The excellent repeatability as well as the above-average battery life makes this innovative water meter indispensable for the water market.
Typical applications are leak detection in water networks, water consumption measurements and
The meter is best suited for applications without a power supply where exact consumption or flow
rates are required. Of course, the M 5000 can also be used with an available power supply.
The meter can be powered with main voltage and in case of a main failure, it is powered by an internal battery.
Important data are consequently saved.
The M 5000 has been designed for very harsh environmental measurement conditions.
The meter has no moving parts and can be used to measure water containing particles like sand or gravel. The M 5000 is encased in an IP 67 housing (optional IP 68), which makes it a reliable meter even when submerged.
The standard meter is equipped with an internal datalogger which can read-out via an IrDA or RS 232 interface with ModBus? RTU protocol.
The collected data can also be retrieved via radio frequency or GSM/GPRS.
The data can thus be centrally compiled and evaluated.
Power supply Internal Lithium batteries 3,6 V
Optional battery back-up model (AC)
Sizes DN 15 to DN 600 (PTFE / hard rubber)
Battery life span 6 years, optional 12 years
Display LCD, 2 lines
Programming 3 keys
Measuring range 0,03 – 12 m/s
Accuracy ±0.5 % accuracy of rate
±0.5 % accuracy 2,5 mm/s of rate
Repeatability ±0.1 %
Minimum fluid 20 μs/cm
Flow direction Bidirectional
Low-flow detection Separate electrode
Digital outputs 4 x open collector, passive 30 VDC/20 mA, max. 100 Hz
Status outputs Min./max. alarm, flow direction, failure report
Serial communication RS 232, ModBus? RTU, IrDA
External AMR or GSM/GPRS module (optional)
Low-flow cut off 0 – 10 %
Pulse width Programmable up to 500 ms.
Housing Powder coated cast aluminium
Protection class IP 67 (IP 68 optional)
Cable entry Signal cable (outputs) M 20
Signal cable From detector M 20
Remote version Max. 30 m
Ambient temperature -20 °C to 60 °C